Flashing a Nokia device like the TA-1007 (which is the Nokia 6.1 model) using the OST (Online Service Tool) requires following a few steps carefully. Please note that flashing your device can erase all data and might void your warranty. Make sure to back up your data before proceeding.
Here's a step-by-step guide to flash your Nokia TA-1007 using OST Tool:
Prerequisites:
- A Windows PC
- Nokia TA-1007 device (Nokia 2)
- OST Tool (Online Service Tool) software
- USB cable to connect your device to your PC
- Firmware for your device (official ROM files)
Steps:
1. Download Necessary Files
- OST Tool: Download From Here
- Firmware File: You will need the official firmware for the Nokia 2 (TA-1007)From Here
2. Install OST Tool on Your PC
- Run the OST Tool installer and follow the on-screen instructions to complete the installation on your PC.
3. Prepare the Nokia TA-1007
- Charge Your Device: Ensure the device is sufficiently charged (at least 50%).
- Enter Download Mode (Emergency Download Mode):
- To enter Download mode on the Nokia TA-1007, you may need to connect your device to the pc Hold the Volume Down button + Power button together to force the device into Download mode
4. Launch OST Tool
- Open the OST Tool on your PC.
- The tool should automatically detect your connected device in Download mode. If it doesn't, make sure the drivers are installed correctly and the device is properly connected.
7. Select Firmware File
- In OST Tool, browse to the location of the Nokia 2 TA-1007 firmware you downloaded earlier.
- Load the firmware into the OST Tool.
8. Start Flashing
- Click on the Start or Flash button in the OST Tool to begin the flashing process.
- The tool will begin flashing the official firmware onto your device. This process may take several minutes.
9. Wait for Completion
- Wait for the OST Tool to finish flashing the device. It may reboot automatically once the process is complete.
10. Reboot Your Device
- Once the flashing is completed, your Nokia TA-1007 should reboot automatically. If it doesn’t, you can manually restart it.
11. Set Up Your Device
- After the reboot, you can proceed with setting up your device as a new phone or restoring your data if you have a backup.
Troubleshooting:
- If the tool doesn’t detect your device, double-check the Download mode process, and ensure the proper drivers are installed.
- Make sure you are using the correct firmware for your specific device model (TA-1007).
- If the device fails to boot after flashing, try re-flashing or consider using recovery tools.
Remember, flashing your phone carries risks, and you should proceed only if you’re confident in the process. If in doubt, seek help from a professional.